Bone Wall Block Selection

[Karnaj]

I also think it's fine the way it is. I'm pretty sure the attack order goes from left to right, starting from the middle row of creatures, followed by the bottom row, and finally the top. Nevermind, disregard that plz.

[Macintosh]

For the middle row with cards labeled 1-7 from left to right, the order is this:

4, 6, 2, 3, 5, 7, 1

For the top and bottom rows, with bottom going before top and 8 cards each:

b1, b3, b5, b7, t1, t3, t5, t7, b2, b4, b6, b8, t2, t4, t6, t8

Someone correct me if I'm wrong, but that's what it is in a nutshell.

[Macintosh]

Zanz intended it so that there's a certain attacking order based on placement. Plus it wouldn't make sense for you to select which of your opponents creatures attack your logically stationary bone walls. It's fine as it is.

[RyzukiSenshi]

There should be a way to pick which of your opponent's creatures your Bone Wall blocks if the number of counters on the Bone Wall is less than the number of creatures your opponent has.  I hate it when it randomly picks which creatures to block and ends up blocking a creature that only does 1 damage over a creature that does 10.  Another solution would be to make it pick the highest attack value first and descend from there so that it always blocks the most possible damage.

[jmizzle7]

I think you are right, Mac, but I'd have to see what you were explaining. If you had a visual it would be a bit more clear. RoKetha, you are partially right. The attacking order is determined by the slot the creature is in, not when the creature came into play. If none of your creatures have been killed or reversed, then they will attack in the order they entered play. If, let's say, you have 6 creatures in play and your bone dragon in slot #3 gets killed, the next creature that enters play on your side will take its place in slot #3 and attack third.

[RoKetha]

I thought it was just that creatures attack in the order they entered play...